TM 5-3810-300-24 & P2
Use two screwdrivers to pry the snap ring into position
inside the clutch gear.
Align one of the holes in the drive gear with the retaining
pin hole and insert the pin from inside the drive gear into
place in the pin hole with the elbow bend facing away
from the clutch gear. Turn the drive gear so the pin
cannot fall out. Use a hammer and punch to bend the
8. Reassemble Intermediate Section.
end of the retaining pin down in between the teeth of the
clutch gear.
Place the intermediate housing on the dowel pins and
against the front case.
4-189