TM 5-3810-300-24&P-3
Crankshaft Oil Seals 1.3.2
(standard size seal) or expander J 4195 with handle J
7. Install the flywheel housing as outlined in Section
8092 (oversize seal) against the end of the crankshaft.
Then, with the lip of the seal pointed toward the engine,
slide the seal over the tool and on the crankshaft.
CAUTION: If the oil seal is of the type
Remove the seal expander and drive the seal in place
which incorporates a brass retainer in
with installer J 9727 and handle J 3154-1.
the inner diameter of the seal, be sure
the retainer is in place on the seal before
6. Remove any excess sealant from the flywheel
installing the flywheel housing on the
housing and the seal.
engine. If the retainer is left out, oil
leakage will result.
PAGE 71
