TM5-3810-305-10 Speed is not to exceed 25 mph (40 km/h). Failure to follow this procedure could cause damage to equipment. CAUTION Traveling with high transmission temperature (above 250 degrees F [121 degrees C]) can cause damage to vehicle. Do not shut engine off when transmission is overheating. C A U T I O N  Never shift between forward and reverse while the LRT 110 Crane is in motion. Failure to follow this procedure could cause damage to equipment. Downshifts should not be made when vehicle speed exceeds maximum speed of next lower range.  Downshifting  at  exces- sive speeds will overspeed drive train components and cause damage to drive shafts Do not operate for extended periods with wide-open throttle at speeds below minimums shown.  Failure  to  follow  this procedure could cause damage to equipment. Under emergency or extreme traveling circumstances, it is possible to stop the LRT 110 Crane with the parking brake. However, this results in rapid brake  wear.  After  stopping  3  or 4 times by this method, parking brake adjustment should be made.  Failure  to  follow  this procedure could cause damage to equipment. CAUTION I A dirty cab can result in damage to instruments and controls. Always consider possible ob- structions which may be encoun- tered during swings when vary- ing boom height or length. Think swing through, consider- ing all obstacles, before making swing.  Failure  to  follow  this procedure could cause damage to equipment. CAUTION I Never hold controls in an “acti- vated’  position  once  hoist/lower cylinder or extend/retract cylin- der has reached its limit of travel, This can cause overheating of hydraulic oil. 1-38 CAUTIO N