TM 5-3810-305-23
0039
INSTALLATION
WARNING
ADHESIVES AND SEALANTS
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause
lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety goggles and
use product in a well-ventilated area away from open flame. If ingested, keep individual calm
and seek medical attention. DO NOT induce vomiting. If contact with skin or eyes is made,
flush thoroughly with water. Dispose of cleanup rags IAW local policy and ordinances.
Failure to follow this warning may cause injury to personnel.
NOTE
Engine shown removed in Figure 2 for clarity.
1.
Install new gasket (Figure 3, Item 6), suction tube (Figure 3, Item 4), capscrew (Figure 3, Item 3), and two
capscrews (Figure 3, Item 5) on engine block (Figure 3, Item 1). Tighten capscrews to 18 ft-lb (24 Nm).
2.
Apply sealing compound to fill joints between oil pan rail, gear housing and rear cover.
NOTE
Oil pan gasket has a print-a-seal surface on one side.
3.
Apply sealing compound to both sides of new gasket (Figure 3, Item 2) and position it with print-a-seal surface
toward engine block (Figure 3, Item 1).
0039-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00044)