TM 5-3810-305-23
0100
REMOVAL
1.
Use outriggers or jack to raise tires off ground.
2.
Support frame with jack stands.
NOTE
Tag all wire assemblies for disconnecting to aid in installation.
3.
Disconnect axle centering indicator electrical wire (WP 0074).
WARNING
Never disconnect hydraulic lines or fittings before venting pressure. Turn dipstick cap 1/4 turn
to safety notch to relieve pressure. Failure to follow this warning may cause death or injury
to personnel.
4.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure.
NOTE
Tag all hose and tube assemblies before disconnecting to aid in installation.
Cap and plug all ports.
5.
Disconnect and cap all hydraulic lines to steering cylinders, brake lines, and breather hose.
6.
Disconnect and remove rear axle lockout cylinders retaining pins (WP 0152).
7.
Remove four capscrews (Figure 1, Item 2) to disconnect rear axle (Figure 1, Item 6) from rear driveshaft spider
bearing assembly (Figure 1, Item 3).
8.
Using hydraulic floor jacks, support rear axle (Figure 1, Item 6).
9.
Matchmark two caps (Figure 1, Item 5) and bushings (Figure 1, Item 4).
10.
Remove eight capscrews (Figure 1, Item 7), washers (Figure 1, Item 8), two caps (Figure 1, Item 5), and grease
fitting (Figure 1, Item 1).
0100-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00110)