TM 5-3810-305-23
0099
INSTALLATION - Continued
5.
Place guide bushing (Figure 5, Item 2) over small end of bowl (Figure 5, Item 3) and push to large portion
of bowl.
6.
Lubricate new o-ring (Figure 5, Item 4) and face seal (Figure 5, Item 6) with ball and roller bearing grease and
install on bowl (Figure 5, Item 3).
NOTE
Make sure o-ring is on rear of guide bushing.
7.
Lubricate with ball and roller bearing grease and install new o-ring (Figure 5, Item 1), guide bushing (Figure 5,
Item 2), bowl (Figure 6, Item 3), new o-ring (Figure 5, Item 4), and face seal (Figure 6, Item 6) as an assembly
into axle housing (Figure 5, Item 5).
8.
Using ball and roller bearing grease, lubricate seal assembly (Figure 5, Item 8) and install on bowl. Fill free
intervals between parts with grease.
WARNING
ADHESIVES AND SEALANTS
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause
lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety goggles and
use product in a well-ventilated area away from open flame. If ingested, keep individual calm
and seek medical attention. DO NOT induce vomiting. If contact with skin or eyes is made,
flush thoroughly with water. Dispose of cleanup rags IAW local policy and ordinances.
Failure to follow this warning may cause injury to personnel.
9.
Apply a bead of silicone sealant around threaded portion of nut (Figure 5, Item 7).
10.
Install nut (Figure 5, Item 7). Turn nut in counterclockwise direction to engage the leading thread. Tighten nut
in clockwise direction to 100 ft-lb (136 Nm).
03/15/2011Rel(1.8)root(maintwp)wpno(M00109)
