TM 5-3810-305-23
0112
REMOVAL
WARNING
Never disconnect hydraulic lines or fittings before venting pressure. Turn dipstick cap 1/4 turn
to safety notch to relieve pressure. Failure to follow this warning may cause death or injury
to personnel.
NOTE
The following is a maintenance procedure for one steering cylinder assembly.
The maintenance procedure for the remaining three steering cylinders is identical.
1.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure.
NOTE
Tag all hose and tube assemblies before disconnecting to aid in installation. Cap and plug
all ports. Remove caps, plugs, and tags following maintenance.
2.
Disconnect two hydraulic lines (Figure 1, Item 6) from elbows (Figure 1, Item 4).
3.
Remove two elbows (Figure 1, Item 4) and o-rings (Figure 1, Item 5) from steering cylinder assembly
(Figure 1, Item 8). Discard o-rings.
4.
Remove two capscrews (Figure 1, Item 3) and washers (Figure 1, Item 2) from steering
cylinder assembly (Figure 1, Item 8).
5.
Drive out two pins (Figure 1, Item 1) from steering cylinder assembly (Figure 1, Item 8).
6.
Remove four washers (Figure 1, Item 7) and steering cylinder (Figure 1, Item 8) from vehicle.
0112-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00125)