TM 5-3810-305-23
0125
REMOVAL
1.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure.
NOTE
Tag all hose and tube assemblies before disconnecting to aid in installation. Cap and plug
all ports. Remove caps, plugs, and tags following maintenance.
2.
Disconnect two hydraulic hoses (Figure 1, Item 5) from two elbows (Figure 1, Item 6).
3.
Remove two elbows (Figure 1, Item 6) from brake valve assembly (Figure 1, Item 7).
4.
Remove four locknuts (Figure 1, Item 3), washers (Figure 1, Item 2), and capscrews (Figure 1, Item 1)
from winch base (Figure 1, Item 4). Discard locknuts.
WARNING
Weight of winch is approximately 300 lb (136 kg). Use adequate lifting equipment to lift and
support winch. DO NOT lift over personnel or let personnel walk underneath suspended load.
Failure to follow this warning may cause injury or death to personnel.
5.
Attach hoist and sling to winch base (Figure 1, Item 4) and remove from vehicle. Lower onto flat surface.
2,3
4
5
1
6
7
M0648105
Figure 1. Winch Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00141)