TM 5-3810-305-23
0151
INSTALLATION - Continued
4.
Position two new o-rings (Figure 15, Item 2) on hold valve (Figure 15, Item 3) and install with two new
lockwashers (Figure 15, Item 4) and capscrews (Figure 15, Item 5) on outrigger cylinder (Figure 15, Item 1).
1
2
3
4
5
4
M0447105
Figure 15.
Outrigger Cylinder Installation.
5.
Start engine. Extend outrigger cylinder rod to align outrigger cylinder rod end with beam. Check for leaks.
Shut engine OFF.
6.
Install pin (Figure 16, Item 3) into pin (Figure 16, Item 2).
7.
Install pin (Figure 16, Item 2) and drive pin into beam (Figure 16, Item 1).
WARNING
Do not remove lifting device until hydraulic pressure has been built up. Failure to follow these
warnings may result in damage to equipment or injury or death to personnel.
8.
Remove suitable lifting device supporting outrigger beam (Figure 16, Item 1) and outrigger cylinder assembly
(Figure 16, Item 4).
9.
Check hydraulic oil level. Fill to proper level, if necessary (TM 5-3810-305-10).
03/15/2011Rel(1.8)root(maintwp)wpno(M00167)