TM 5-3810-306-20
d.
Install knob (1) on shift lever (2).
2.
ADJUST LINKAGE AS NECESSARY.
a.
To obtain full travel of transmission shift valve
spools, remove clip pin (9) and clevis pin (8).
b.
Loosen locknut (10) and turn clevis on linkage
(7) to increase or decrease valve spool travel.
c.
Tighten locknut (10) and install clevis pin (8) and
clip pin (9).
3.
CONNECT GROUND CABLE AT SHUNT. (REFER
TO PAGE 8-109.)
4.
INSTALL ACCESS PANEL TO SIDE CONSOLE.
(REFER TO PAGE 8-21.)
5.
INSTALL OPERATOR SEAT. (REFER TO PAGE
15-27)
6.
TEST FOR PROPER OPERATION. (REFER TO
TM 5-3810-306-10.).
END OF TASK
9-3
