TM 5-3810-306-20
d
Place other flange (5) on wheel and install bead
seat (4). suitable hammer, force bead seat down
as far as possible.
e.
. Install new preformed packing (3) in second
groove.
f.
Place lock ring (2) in top groove with split
opposite the valve stem. Standing on tire pry
lock ring into groove by snapping it into place.
g.
Lubricate the preformed packing (3) and bead
seat (4) with vegetable-based lubricant.
h.
Inspect all rim parts to ensure that they are
seated properly. Lock ring (2) should be fully
seated.
i.
Place tire and rim in safety cage.
j.
Using clip-on inflator, inflate tire to approximately
3 psi. Check all parts for proper alignment.
k.
If parts appear okay, continue to inflate tire to 75
psi. If parts appear unseated, stop, deflate tire
and reassemble rim parts.
2.
INSTALL TIRE AND WHEEL ASSEMBLY. (REFER
TO PAGE 12-2.)
END OF TASK
12-5/12-6 Blank
