TM 5-3810-306-20Section I. STEER CYLINDER MAINTENANCESTEER CYLINDER INSTALLATIONTOOLS: General mechanic’s tool kit: automotive (5180-00-177-7033)SUPPLIES:Lockwashers (Item 16, Appendix C) (2 Required)EQUIPMENT CONDITIONS: Disconnect ground cable at shunt. (Refer to page 8-109.)REMOVAL:NOTEFront and rear steer cylinders areidentical. Use this procedure for both.1.REMOVE STEER CYLINDER (1).a.Tag and disconnect two hydraulic lines to steercylinder (1).b.Remove capscrew (2), lockwasher (3),flatwasher (4) and cotter pin (5) from base endof steer cylinder (1). Remove pivot shaft (7).Discard lockwasher (3).c.Remove capscrew (6), lockwasher (3),flatwasher (4) and cotter pin (5) from rod side ofsteer cylinder. Remove pivot shaft (7). Discardlockwasher (3).NOTEEnsure capscrews (2 and 6) arereinstalled in their correct locations.The rod end capscrew has coarsethreads and base end capscrew hasfine threads.d.Remove steer cylinder (1).13-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
