TM 5-3810-307-10
CAUTION
Always select an outrigger beam or stabilizer cylinder
using the OUTRIGGER SELECTOR Switches (40,
EXTEND/RETRACT Switch (54) to either EXTEND
or RETRACT. Failure to follow this caution could
cause a hydraulic lock against the individual solenoid
valves, thus preventing them from moving.
NOTE
More than one outrigger beam can be extended at
one time. However, each OUTRIGGER SELECTOR
Switch (40) should be depressed individually while
momentarily holding the OUTRIGGERS EXTEND/
RETRACT Switch (54) at EXTEND to ensure that
each outrigger beam is fully extended.
b.
Select and hold the appropriate OUTRIGGER SELECTOR Switch (40) to
extend the front outrigger beam(s). Then place and hold the OUTRIGGERS
EXTEND/RETRACT Switch (54) in the EXTEND position until front outrigger
beam(s) is fully extended.
c.
Select and hold the appropriate OUTRIGGER SELECTOR Switch (40) to
extend the rear outrigger beam(s). Then place and hold the OUTRIGGERS
EXTEND/RETRACT Switch (54) in the EXTEND position until rear outrigger
beam(s) is fully extended.
d.
Extend the front stabilizer cylinders in order to lock the floats onto the ball
end of the stabilizer. To do this, first select and hold the OUTRIGGER
SELECTOR Switch (40). Then select and hold the OUTRIGGERS
EXTEND/RETRACT Switch (54) in the EXTEND position while repositioning
the float(s) as necessary to line up the float socket with the ball end of the
cylinder. Ensure float locking levers are properly locked and floats are firmly
touching the ground.
e.
Repeat step d. for the rear stabilizers and floats by selecting and holding the
OUTRIGGER SELECTOR Switch (40).
f.
With each stabilizer float firmly touching the ground, select and hold the
OUTRIGGER SELECTOR Switch (40).
Then select and hold the
OUTRIGGERS EXTEND/RETRACT Switch (54) in the EXTEND position to
extend the front stabilizers approximately 3 to 4 inches (7.6 to 10.2 cm).
g.
Repeat step f. for the rear stabilizers and floats by selecting and holding the
OUTRIGGER SELECTOR Switch (40).
5-81
