SM02-025-0
Change-1 Page 67
14.
Turn the clutch over and tap the clutch
shaft on a block of wood to remove the clutch
piston.
NOTE
Assembly.
Belleville washers in the 1st and 2nd
clutch are different than washers in the
forward and reverse clutch, 1st and 2nd
clutch washers have (4) four holes in
them (for identification only). Do not mix
1st and 2nd clutch washers with forward
and reverse washers.
12.
Remove the return springs (Bellevile
washers).
NOTE
The ring must be sized before installing
in clutch drum. Sizing is best accomp-
lished by rotating the piston while hold-
ing a round object against the new seal
ring as shown. Rotate the piston until
the seal ring is flush with the outer
diameter of piston.
13.
Remove the piston spacer.
1.
Install the clutch piston outer seal ring.