TM 5-3810-307-24-1-2
NOTE: 0.25" DIA. HOLES SHOULD
1.75
BE DRILLED BEFORE DRILLING
0.53
THE 1.0" DIA. HOLE IN TANK
1.06
1.0" DIA. HOLE FOR
FUEL PICK-UP TUBE
(2) 0.25" DIA. HOLES
1/2" NPT VENT AND
FOR WASHER ACCESS
GUARD WITH BARBED
HOSE FITTING (REF)
3.50
0.16
3/8" NPT FEEDLINE (REF)
FUEL TANK
5.00 (REF)
TOP VIEW
Figure J-2. Fuel Tank Modification Dimensions
d.
Drill the one 1.0" diameter hole in the fuel tank.
e.
Clean the edges of the 1.0" diameter hole using a round file.
f.
Remove nut (1, Figure J-3), flat washer (2), and rubber washer (3) from fuel pickup tube
- P/N CA0 12 058 (4). The second flat washer (5) should remain on the fuel pickup tube
(4).
g.
Insert fuel pickup tube - P/N CA0 12 058 (4) and flat washer (5) into the 1.0" diameter
hole in the fuel tank. The flat washer (5) should slide through the gap created by the two
0.25" holes.
h.
Slide rubber washer (3), flat washer (2), and nut (1) over fuel pickup tube - P/N CA0 12
058 (4), align hose connection of fuel pickup tube to face the front left hand corner of the
fuel tank (when viewed with fuel tank installed on crane), and tighten nut (1).
i.
Turn the fuel tank over with filler cap down. Then clean the inside by spraying a
phosphate cleaner through the filler cap opening while draining cleaner and residue from
the filler cap opening. Rinse with clean water and completely dry inside of tank using
compressed air.
j.
Reinstall fuel tank in accordance with Technical Manual, TM 5-3810-307-24-1-1.
Change-1 J-9