TM 5-3810-307-24-1-2
Accessory Tools and Components
The accessory tools and components are initially provided with the Pile Driver System and located in
two tool boxes that are housed in the shipping/storage container. Identification and weight data is
stenciled on the sides of the tool boxes. The accessory tools and components include rigging and
safety equipment, shipping/storage equipment, accessories and adapters, ground servicing tools,
special tools, consumable materials such as lubricants, seal kits and spare filters, and miscellaneous
spare parts.
The rigging and safety equipment include the following:
One trip safety lever cord (3/8" x 100 ft (10 mm x 30.5 m))
One piston lifting eyebolt
Two 96-inch (2.44 m) wire rope lifting slings
Two 89-inch (2.26 m) wire rope lifting slings
Two 72-inch (1.8 m) wire rope lifting slings
Two nylon lifting slings
One H-type pile lifting sling (30-inch (76 cm))
Two H-type pile chain lifting slings with hooks
Two one-inch (2.5 cm) shackles
Two 7/8-inch (2.2 cm) shackles
Eight 3/4-inch (1.9 cm) shackles
Two ground-release shackles
One temporary hydraulic hose retainer chain (5/16 x 90-inch (0.8 x 229 cm))
Four 4x4-inch (10 x 10 cm) wood blocks
1/2 x 48-inch (1.3 cm x 1.22 m) long wire cable
5/8 x 96-inch (1.6 cm x 2.44 m) long wire cable and 5/8-inch (1.6 cm) clamps for rigging the
square (concrete) and sheet pile adapters
The shipping/storage equipment is red in color and used to protect and secure the impact hammer for
storage and/or transportation. The equipment includes the catch ring weather cap and securing strap,
intake/exhaust port weather cap, piston transportation pin and clip, and trip transport bolt.
The accessories and adapters are used to drive different size piles (wood other than 18-inch (45.7 cm
and steel H-beam), pre-cast concrete, or sheet piles. The adapters include the following:
10-inch (25.4cm), 12-inch (30.5 cm), and 16-inch (40.6 cm) guide plates
18-inch (45.7 cm) square (concrete) pile adapter
Sheet pile adapter
Plywood template for the 18-inch (45.7 cm) square (concrete) pile adapter
The guide plates are bolted onto the lower drive housing of the direct drive assembly and replace the
standard 18-inch (45.7 cm) guide plate. The size of the guide plate indicates the inside diameter. The
square (concrete) pile adapter and sheet pile adapter are installed in the direct drive assembly and
secured via cables and clamps to the adapter holes located at the bottom of the lower cylinder. The
adapter holes are the lower holes directly below the impact hammer lifting lugs. Weight data is
stenciled on the sides of the pile adapters. The plywood template for the 18-inch (45.7 cm) square
(concrete) pile adapter can be used by operating personnel to fabricate a cushion to prevent damage to
the square concrete piles during operation.
The ground servicing tools are used to add fuel and oil to the fuel and lubrication systems and to drain
the waste fuel drip tank on the impact hammer. The ground fueling tools include a ground fueling hand
pump and ground fueling hose and quick connect fitting. The ground oiling tools include a ground oiling
hand pump and ground oiling hose and quick connect fitting. A waste fuel drip tank drain hose and
quick connect fitting is also provided.
Change-1 K-15