TM 5-3810-307-24-1-2
The hydraulic hose is connected to the remote throttle via a quick connect fitting and is routed to the
lower cylinder section of the impact hammer. The hydraulic hose is connected to the throttle valve whip
line of the throttle valve (needle block) that is identified by a "THROTTLE CONNECTION" label. The
pulley with 15-inch (38 cm) anchor bungee, normally stored in the toolboxes, can be attached to the
hydraulic hose reel on the crane boom to ensure the hydraulic hose is kept out of the way during pile
driving operations by holding a rope tied to the hydraulic hose.
Remote
Throttle
Vent
Bracket
Location
Remote
Throttle
Self Tapping
Screws
Fill Plug (On Far Side)
Pressure
Gauge
Quick Connect
Fitting
Pressure
Remote Throttle
Relief
Hydraulic Hose
Valve
Figure K-5. Remote Throttle
K-14 Change-1