TM 5-3810-307-24-1-2
Cushion Housing Guide Ring Support and Cushion Housing Guide Ring. (Refer to Figure K-19.)
The cushion housing guide ring support and cushion housing guide ring are normally removed for
replacement.
Removal.
a.
Remove the direct drive assembly as an assembly from the lower cylinder (Page K-44).
b.
With the direct drive assembly standing upright, remove the cushion housing guide ring
support (1, Figure K-19) and cushion housing guide ring (2) from the cushion housing of
the direct drive assembly.
NOTE
The 3/8-16 UNC tapped holes in the cushion housing guide ring support
(1) allow bolts or threaded rods to be used to pull the cushion housing
guide ring support (1) and cushion housing guide ring (2) out of the
cushion housing of the direct drive assembly.
c.
Separate the cushion housing guide ring support (1) and cushion housing guide ring (2)
from each other.
LOWER
CYLINDER
FLANGE (REF.)
IMPACT
BLOCK
(REF.)
CUSHION
HOUSING
(REF.)
UPPER TO
LOWER DRIVE
HOUSING BOLTS
(REF.)
1
2
DIRECT DRIVE
ASSEMBLY (REF.)
LEGEND
1.
Cushion Housing Guide Ring Support
2.
Cushion Housing Guide Ring
Figure K-19. Cushion Housing Guide Ring Support and
Cushion Housing Guide Ring Installation
K-48 Change-1