TM 5-3810-307-24-2-2
Fuel Shut Off Solenoid Adjustment,
Bosch P7100 (5-33)
NOTE
The fuel pump solenoid must be adjusted on
the vehicle to access the voltage supply.
Connect the solenoid wiring harness to the vehicle
wiring harness.
Turn the key to the "ON" position. This will energize
the red (hold) wire and black (common) wire.
This is the low current hold-in coil and must be
energized continuously during this adjustment.
NOTE
Do not turn the key to the "START" position
at this time. This will energize the white (pull-
in) wire.
Move the shut off lever by hand to the full run
position.
10 mm, 16 mm
Adjust the solenoid linkage to dimension A.
Dimension A is measured from the bottom surface
of the solenoid mounting bracket to the top of the
pivot pin. When properly adjusted the plunger is
magnetically held in with the shut off lever in the
absolute full run position. Turn the large hex on the
end of the plunger to make adjustments.
Solenoid Run Dimension
A = 66.9 mm [2.6 in]