NOTE
REMOVE DRAIN PLUG AND DRAIN OIL BEFORE REMOVING CHAIN CASE COVER. AT
INSTALLATION, REFER TO CURRENT LUBRICATION ORDER AND REFILL THROUGH FILL PIPE
UNTIL OIL RUNS OUT OF LEVEL PLUG HOLE.
Figure 3-83. Transfer chain case cover, removal and installation.
(3) Install in reverse order.
(3) Remove lockwire from two screws in input
shaft (fig. 3-84).
b. Cleaning, Inspection, and Repair.
(4) Remove two screws and plate, then remove
(1) Clean chain in an approved cleaning
input shaft sprocket from input shaft.
solvent and dry thoroughly.
(5) Install in reverse order.
(2) Visually inspect chain for damaged links,
b. Cleaning, Inspection, and Repair.
pins, or cotterpins.
(3) Repair by replacing damaged links, pins, or
(1) Clean all parts in an approved cleaning
removed cotterpins.
solvent and dry thoroughly.
3-107. Input Shaft Chain Sprocket a. Removal and
(2) Visually inspect mounting hardware for burs
Installation.
or stripped threads. Inspect sprocket for cracked or
broken teeth.
(1) Remove transfer chain case cover (para 3-
105).
(3) Repair by replacing a damaged sprocket, or
defective hardware.
(2) Remove transfer chain (para 3-106).
3-90
