TM 5-3810-206-35
1
Capscrew (6 rqr)
7
Bolt (2 rqr)
11
Idler gear
16
Bolt (4 rqr)
2
Shaft end cap
8
Bearing cap
12
Collar
17
Outboard bearing
3
Main hoist shaft
(2 rqr)
13
Lockwasher (2 rqr)
support
4
Bolt (2 rqr)
10
Revolving frame
14
Capscrew (2 rqr)
18
Outboard bearing
5
Nut (2 rqr)
sidestand
15
Nut (4 rqr)
bracket
6
Lockwasher
(2 rqr)
Figure 4-5. Main hoist shaft, left side installed view.
5-3810-206-12) then refer to figure 4-7 and disassemble
(7) Remove cotterpin (28), pin (27), and cam
in the following order:
(29) from clutch shifter (16), then pull clutch shifter off
(2) Remove eight capscrews (65), lockwashers
clutch spider (39).
(62), adapter ring (61), gasket (59), adapter ring (60),
(8) Remove spacer (40), washer (12), and
and gasket (59).
gasket (13), from shaft (38).
(9) Remove clutch shoes from clutch drum (TM
bolts (58) from adapter ring (57) and bearing retainer
5-3810-206-12).
(50).
(10) Remove clutch spider (39), oil seal (19),
(4) Remove adapter (57), gasket (56), shims
clutch drum (20), packing (21), and oil seal (22) from
(54), and seal (53) from bearing housing (52).
shaft (38) and remove pin (24) from clutch spider (39).
(5) Remove bearing housing (52), bearing (51),
(11) Remove bearing (23) and spacer (30), then
bearing retainer (50), and spacer (55) from shaft (38).
press beveral gear (32), bearing (23), and spacer (33)
from shaft (38).
capscrews (15), and shifter collar (14) from clutch shifter
(12) Use a bearing puller and remove bearing
(16).
(23) from center bearing housing (35).
4-7