TM 5-3810-207-20/TO 36C23-3-37-12
A—Removal and adjustment clearance
Figure 73. Front conical rollers, removal, disassembly, reassembly and installation.
b.
Disassembly. Disassemble the front conical
rollers in numerical sequence as illustrated on figure 73.
c.
Cleaning and Inspection.
(1) Clean all parts with an approved
cleaning solvent.
(2) Inspect all parts for excessive wear,
breaks, cracks, and other damage.
Replace all defective parts.
d.
Reassembly. Reassemble the front conical
rollers in the reverse sequence as illustrated on figure
73.
e.
Installation. Install the front conical rollers
as illustrated on figure 73.
f.
Adjustment. When installing the roller
plates, install the required amount of shims to obtain
0.035 inch clearance between the rollers and roller
circle.
145. Rear Conical Rollers
a.
Removal.
(1) Place adequate cribbing between carrier
frame and rear underside of main
frame.
(2) Remove the rear conical rollers as
instructed on figure 74.
b.
Disassembly. Disassemble the rear conical
rollers in numerical sequence as illustrated on figure 74.
c.
Cleaning and Inspection.
(1) Clean all parts with an approved
cleaning solvent.
(2) Inspect all parts for excessive wear,
breaks, cracks, and other damage.
Replace defective parts.
106
