lubrication. The shaft bearing is made of porous metal
400.
Carrier
Engine
Distributor
Assembly
and extends from the upper to the lower part of the
Cleaning, Inspection, and Repair
housing, spanning an oil reservoir. During operation,
the oil seeps through the bearing, providing continuous
a.
Cleaning. Clean all parts with a dry, lint-free
shaft lubrication over relatively long periods of time.
cloth and compressed air.
b.
Inspection and Repair. Inspect all parts for
399.
Carrier Engine Distributor Assembly Removal
excessive wear or damage. Replace or repair all
and Disassembly
defective parts.
a.
Removal.
Remove the carrier engine
401.
Carrier
Engine
Distributor
Assembly
distributor assembly (para. 98).
Reassembly and Installation
b.
Disassembly.
Disassemble the carrier
engine distributor assembly in a similar manner as
a.
Reassembly Reassemble the carrier engine
described in paragraph 324.
distributor assembly in a similar manner as described in
b.
Installation.
Install the carrier engine
distributor assembly (para. 98).
Section XXIX. CARRIER ENGINE ACCESSORY DRIVE ASSEMBLY
402.
General
The carrier engine accessory drive assembly is
externally mounted on the left side of the carrier engine
block. The accessory drive assembly is driven from the
carrier engine camshaft gear by a helical gear which
also drives the carrier engine oil pump assembly. The
distributor is mounted on top end of the accessory drive
shaft. The drive shaft for the governor drive cable is
also mounted on the accessory drive housing and is
gear-driven from the accessory drive shaft.
403.
Carrier Engine Accessory Drive Assembly
Removal and Disassembly
a.
Removal.
(1) Remove the carrier engine governor
drive cable and distributor assembly
(2) Remove the carrier engine accessory
drive assembly as instructed on figure
b.
Disassembly.
Disassemble the carrier
engine accessory drive assembly in numerical sequence
as illustrated on figure 212.
404.
Carrier Engine Accessory Drive Assembly
Cleaning, Inspection and Repair
Figure 211. Carrier engine accessory drive
assembly removal and installation.
a.
Cleaning. Clean all parts with an approved
cleaning solvent and dry thoroughly.
AGO 6819A
234
