B-Fuel
Figure 3-23. (2) Continued.
c. Remove injectors from cylinder heads as
e. Inspect thread conditions on all screws and
illustrated on figure 3-23.
rocker levers. Replace defective or damaged parts.
NOTE
3-46. Installation
Use a rolling head pry
bar to remove the
a. Install injectors in cylinder heads as instructed
right and left front
on figure 3-23.
injectors.
b. Install rocker lever assemblies as instructed
on figure 3-23.
3-45. Cleaning, Inspection and Repair
c. Adjust the fuel injector plungers (TM 53810-
a. Clean all parts with an approved cleaning
232-12).
solvent.
d. Adjust the valve crossheads (TM 5-3810232-
b. Inspect all parts for cracks, burrs, pitting,
12).
excessive wear and damaged threads.
Replace
e. Adjust valve clearance (TM 5-3810-232-12).
defective parts as necessary. See table 1-1.
f.
Install cylinder head covers and push the tube
c. Inspect and see that all lubricating oil
covers (para 3-43).
passages are open and unobstructed.
d. Inspect lever shaft for scoring, goring and
wear. Replace if worn smaller than 1.1845 inches.
3-43
