4-47. Installation
a Install damper as illustrated on figure 4-10.
b With a dial gage check vibration damper
eccentricity and wobble at points A and B E shown on
c 'Eccentricity of damper must not exceed 0.010
inch and wobble 0.010 inch @ 4 inch radius. The adapter
hub eccentricity must not exceed 0.004 inch and wobble
0.003 inch @ 2 3/4 inch radius.
NOTE
Keep crankshaft thrust clearance to front
or rear limit while checking wobble.
Figure 4-11. Vibration damper and adapter hub
eccentricity and wobble check.
Section XIV. CRANE ENGINE FLYWHEEL AND FLYWHEEL HOUSING
c. Remove the flywheel and flywheel housing as
4-48. Removal
illustrated on figure 4-12.
a Remove engine (para 2-9).
b. Remove the starter (TM
5-3810-232-12).
A-Flywheel removal
Figure 4-12. (1) Flywheel and flywheel housing, removal and installation.
4-18
