TM 5-3810-289-34
Figure 3-116. Oil transfer connection, removal and
Figure 3-115. Accessory drive pulley installation.
installation.
d. Installation.
3-26. Oil Lines
(1) Insert key (5, fig. 3-114 in accessory
a. General Hose used for lubricating or fuel oil
drive shaft.
lines should consist of a seamless synthetic rubber inner
(2) Slide pulley onto shaft until it binds.
tube reinforced with fabric braiding and wire braiding,
(3) Using ST-386 Pulley Assembly Tool,
and covered with a synthetic rubber-impregnated oil-
press pulley onto drive shaft as illustrated in figure 3-115.
resistant fabric braid or rubber coating. The minimum
(4) Install flatwasher and locknut.
flexible hose sizes and hose bends are given in table 2-
(5) Tighten locknut to 90/100 ft.-lb.
3-24. Fuel Pump Accessory Drive Assembly
b. Inspections. Inspect oil and fuel oil lines for
a. Removal and Disassembly.
cracks, breaks, and other damage.
(1) Remove fuel pump accessory drive
c. Replacement. Replace defective lines.
pulley (para 3-23).
3-27. Water Header Plate
(2) Remove four mounting bolts and remove
a. Removal
and disassemble accessory drive (fig. 3-114).
(1) Remove capscrews and lockwashers
b. Cleaning and Inspection.
securing plate to block.
(1) Clean parts in an approved cleaning
(2) Remove plate and gasket from engine,
solvent and dry thoroughly.
(2) Inspect for damaged or defective parts.
b. Installation. Position water header cover plate
c. Repair. Replace damaged or defective parts.
to side of cylinder block with new gasket; secure with
d. Reassembly and Installation.
lockwashers and capscrews.
(1) Reassemble accessory drive assembly
(2) Position drive assembly on mount; install
and tighten four mounting bolts.
(3) Install accessory drive pulley (para 3-
3-25. Oil Transfer Connection
a. Removal
(1) Remove capscrews, lockwashers and
flat washers from oil transfer connection (fig. 3-116).
(2) Remove connection from block and
discard gaskets.
b. Installation. Position oil transfer connection and
new gaskets to block; secure with flatwashers,
lockwashers and capscrews.
Figure 3-117. Water header plate, removal and
installation.
3-43
