3-17. Engine Control Panel Inspection
Inspect the engine control panel, panel wiring and
switches for damage or loose hardware.
3-18. Panel Gage Inspection
Inspect panel gages for any obvious damage. During
operation, monitor gages for proper operation.
3-19. Inspection of Lights
Refer to the crane controls illustration, figure 2-32, and to
the carrier controls illustration, figure 5-1. Turn on each
internal cab light and external light, in turn. and check
for correct operation. Check headlights in both the bright
and dim conditions. Check directional signals in both
directions. Check the operation of the two reel-mounted
lights, one in each cab. Be sure dome and dash board
lights operate. See that floodlights are adjusted so as to
provide adequate lighting around the entire working area.
Report any deficiencies to organizational maintenance.
3-20. Inspection of Horns
Depress the crane horn button (fig. 2-32) and the carrier
horn (fig. 5-1 and see that the horns operate properly.
Check visible wiring to horn buttons for worn or frayed
insulation.
Report deficiencies to organizational
maintenance.
3-21. Battery Inspection and Service
a. Inspect. Refer to figure 3-7, and inspect
batteries for c(racks. leaks, or other damage. Inspect
cables for frayed insulation. broken wires, bent or
broken lugs, or corroded terminal lugs. Clean
terminals and cable lugs of all corrosion and lubricate
terminals and lugs with a light coating of grease as
specified in the current LO. Inspect the battery box for
cracks. breaks, corrosion, or other damage.
Figure 3-7. Battery inspection and service.
3-10
