TM 5-3810-294-34
j.
Install the carbon button (6) in the cap (3).
h. Install the condenser (9) in the bracket (8)
Install the cap and secure it with screws (2 and 1).
and attach the bracket to the plate with screws (7).
k. Install the distributor as outlined in TM 5-
i.
Set the dust seal (5) in place. Oil the wick
3810-294-20.
(14) and install the rotor (4).
Section IV. REPAIR OF CARBURETOR
3-19. Description
3-20. Removal
The carburetor is of the updraft double venturi type. It is
Refer to TM
5-3810-294-20
for instructions to
designed to maintain proper fuel mixtures even though
disconnect the fuel lines, controls, linkages, and removal
the vehicle is on very steep slopes. It is a "sealed and
of the carburetor from the engine.
balanced" type, in that all air for bowl chamber ventilation
3-21. Disassembly
and idling must come through the air filter.
Refer to figure 3-4 and disassemble the carburetor as
follows:
KEY to FIG. 3-4.
1. Flange gasket
23. Screw
44.
Plug
2. Screw a lockwasher (2)
24. Lockwasher (3)
45.
Washer
3. Throttle plate
25. Choke plate
46.
Main jet
4. Screw (6)
26. Choke shaft
47.
Main jet washer
5. Lockwasher (6)
27. Nut
48.
Washer
6. Felt seal
28. Choke bracket
49.
Plug
7. Throttle shaft bearing
29. Choke bracket clip
50.
Check valve
8. Seal retainer
no Screw
51.
Power jet valve
9. Throttle shaft
31. Choke lever screw
52.
Float axle
10. Throttle lever and stop lever
32. Choke lever nut
53.
Fuel needle valve
11. Throttle stop screw
33. Lockwasher
54.
Fuel valve seat
12. Pin
34. Choke lever
55.
Valve seat washer
13. Venturi screw
35. Choke return spring
56.
Idle jet
14. Lockwasher
36. Bracket retaining screw
57.
Idle needle spring
15. Throttle body
37. Fuel bowl
58.
Idle adjusting needle
16. Pump assembly
38. Plug
59.
Throttle shaft bearing
17. Float assembly
39. Plug
60.
Cup plug
18. Gasket
40. Discharge jet washer
61.
Vacuum channel screw
19. Venturi
41. Discharge et
62.
Filter element
20. Well vent jet
42. Washer
63.
Washer
21. Accelerating jet
43. Plug
64.
Filter head
22. Accelerating jet washer
3-8
