TM 5-3810-294-34
5-13. Reassembly
5-14. Installation
Refer to figure 5-5 and assemble the propeller shaft.
Refer to TM 5-3810-294-20 and install the propeller
shaft.
Section III. REPAIR OF CRANE WORM SHAFT
a. Remove cotter pin (1), nut (2), flange (3), and key
5-15. Description
(12). Nut (4) and lockwasher (5) are removed during
The worm shaft drives the worm wheel on the boom
removal of the assembly from the machine.
hoist shaft assembly (refer to fig. 5-1).
b. Remove retainer (7). Oil seal (6) comes off shaft
5-16. Removal
(13) in the retainer.
Refer to paragraph 2-19 and remove the worm shaft
c. Remove shims (8, 9, and 10). Remove shaft (13)
assembly.
from worm sleeve (15). Bearings (11 and 14) are
5-17. Disassembly
removed with the shaft.
Refer to figure 5-6 and disassemble the worm shaft as
follows:
5-11
