Table 11B-1. Cylinder Bore Clearances
Figure 11B-16. Checking Top Face of
Cylinder Block
6. If it is necessary to machine the top
surface of the block to correct for the
above conditions, do not remove-more
than 0.008" of metal. Stamp the
amount of stock removed on the face
of the block. The distance from the
centerline of the crankshaft to the top
of the block must not be less than
16.176"
(see
Figure
11B-17
on
Figure 118-15. Boring Cylinder Block
with
Portable
Boring
Bar
Engine (Less Major Assemblies) 11B-9