NOTE
A 0.002" thick shim is available for
The
adjusting the liner height.
shim must be installed underneath
Do not cut the
the liner insert.
4. Install a cylinder liner hold-down
shim for installation. Liner inserts
c l a m p a s s h o w n i n Figure
11B-137
on
which are 0.0015" thicker or thin-
page 11B-89.
ner than standard are also avail-
able for service. In addition, the
5. Measure the distance from the top of
0.004" and 0.008" thinner inserts,
the liner to the top of the block with a
which are provided for use with
dial
indicator
(see
on
resurfaced cylinder blocks, can al-
page 11B-89). The liner flange must be
so
be
used
to
adjust
the
liner
0.045" to 0.050" below the surface of the
height.
However, even through all of the
block.
liners are within these specifications,
there must not be over 0.002" difference
6. Matchmark the liner and the cylinder
in depth between any two adjacent liners
block with a felt pen so the liner may be
when measured along the cylinder longi-
reinstalled in the same position in the
tudinal center line.
11B-88