F i g u r e 11B-130. Removing Cylinder
Liner
cleaned and then checked for:
Cracks
Scoring
Poor contact on outer surface
Flange irregularities
Figure 11B-129. Cylinder Liner
Inside diameter
Outside diameter
A. Slip the lower puller clamp up on the
Out-of-round
puller rod and off the tapered seat.
Taper
Cock the clamp so it will slide down
The clamp will
through the liner.
drop back on the tapered seat after it
clears the bottom of the liner. Then
slide the upper puller clamp down
against the top edge of the liner.
B. With the tool in place, strike the up-
set head on the upper end of the pul-
ler rod a sharp blow with the puller
weight, thus releasing the liner (see
C. Remove the tool from the liner. Then
remove the liner from the block.
D. Remove the liner insert and shims (if
used) from the counterbore in the
block.
E. Tag the liner, insert and shims.
If tool J 1918-02 is unavailable, tap the
liner out with a hardwood block and
hammer.
I n s p e c t Used Cylinder Liner
F i g u r e 11B-131. High and Low
When the cylinder liner is removed from
P r e s s u r e Contact Areas on Cylinder
the cylinder block, it must be thoroughly
Liner
11B-84