seal, i s b o l t e d t o t h e f l y w h e e l h o u s i n g .
The pulley is keyed to the drive shaft
which extends through the drive retainer
assembly.
R e m o v e Accessory Drive
Remove the gear driven type accessory
drive as follows:
1. Remove any external piping or con-
nections to the accessory.
Figure 118-178. Accessory Drive
2. Remove the five bolts and lock wash-
Locations
ers attaching the accessory to the fly-
wheel
housing.
Belt driven accessories, such as battery
Pull
the
accessory
charging generators, are driven off the
straight out from the flywheel housing.
camshaft or balance shaft gears by a ac-
3. Remove the drive coupling.
cessory drive plate, drive shaft, acces-
sory drive retainer assembly and pulley
4. Place a clean, lintless cloth in the
(see Figure 11B-180 on page 11B-118).
The accessory d r i v e p l a t e i s b o l t e d t o
flywheel housing opening, underneath
the accessory drive plate, to prevent
one of the balance gears. The accessory
bolts from accidentally falling into the
drive shaft is splined to the drive plate
gear train.
at one end and supported by a bearing
Remove the four bolts and
in the accessory drive retainer at the
lock washers attaching the accessory
drive
other
end.
accessory
drive plate to the balance gear and re-
The
retainer, which also incorporates an oil
move the plate and spacer.
Figure 11B-179. Direct Drive Accessory Parts
11B-117
Engine (Less Major Assemblies)