Figure 11C-65. Removing Variable
Speed Spring Plunger Guide
C. Thread a 5/16"-24 x 3" bolt into the
tapped end of the weight shaft. Sup-
port the weight housing on the bed of
the press as shown in Figure 11C-69
on page 11C-40, then press the shaft
from the bearing.
Figure 11C-67. Removing Operating
Shaft from Lever
D. Slide the riser thrust bearing and
governor riser from the shaft.
This bearing is specially designed to
absorb thrust load; therefore, loose-
ness between the mating parts does
not indicate excessive wear.
E. Remove the bearing from the weight
housing.
F. Use tool J4880 and remove one lock
ring from each weight pin. Withdraw
the pins, flat washers and governor
weights.
G. If required, the weight carrier
(Figure 11C-68 on page 11C-40) may
be pressed from the governor weight
shaft and a new carrier installed.
4. Disassemble the governor variable
speed spring housing.
A. Refer to Figure 11C-60 on page
11C-36 and withdraw the variable
speed spring, stops, spring plunger
and shims from the spring housing.
B. Loosen the bolt and withdraw the
speed control lever from the speed
control lever shaft. Remove the Woo-
druff key (Figure 11C-72 on page
11C-43) from the shaft.
C. Remove the plain washer and sea!
F i g u r e 11C-66. Removing Operating
from the shaft.
Shaft from Fork
Fuel System and Governor
11C-39