Figure 11C-68 Governor Weight Housing Details
F. If required, the second bearing may
D. R e m o v e o n e s c r e w a n d l o c k w a s h e r
be pressed from the housing.
and remove the spring housing cover
and gasket. Then remove the set
screw from the spring lever.
Inspection
E. S u p p o r t t h e s p r i n g h o u s i n g o n t h e
Clean all of the parts with fuel oil and
bed of the press with the shaft up.
dry them with compressed air.
Use a brass rod and press the shaft,
plug and bearing from the housing.
Inspect all of the governor components
Remove the bearing from the shaft
and replace worn or damaged parts.
and the spring -lever from the
housing.
Revolve the operating shaft bearing and
the governor weight shaft bearing slowly
by hand; replace the bearings if rough
or tight spots are detected.
Inspect the operating shaft and shaft
bushing for excessive wear. If exces-
sive wear is noted, a new bushing and
shaft must be installed.
Examine the riser thrust bearing for ex-
cessive wear, f i a t s p o t s o r c o r r o s i o n . I f
any of these conditions exist, a new
thrust
bearing
assembly
must
be
in-
stalled.
Inspect the needle bearing or bushing
and the control lever shaft for excessive
wear or flat spots. If one or both condi-
tions exists, new bearings and control
shaft must be installed.
Figure 11C-69. Removing Governor
Weight and Shaft