TM5-3810-305-1011. Shut engine off.Be aware of limited work areawhile lifting, reaching andassembling the mast and lift arm.The deck and fender surface issmall and can become slippery ininclement weather. Failure tofollow this procedure could causeDEATH or serious injury.12. Install mast (3) on carrier as follows:Figure 5-10. AssemblingtheMasta. With the aid of another person, raise mastb<c.(3) from deck, and lower it over squarepivot bearing (9, Figure 5-10), located onright side of frame, behind operator’s cab.Position stop on mast (3) towards centerline of vehicle between stops. Mast baseears should be over fender. Align ears ontop of mast with support ears on frame.Remove two truss rods (10), adjustabletruss rod (11 ) and six pins (12) from stor-age location A (Figure 5:11) on right sideof upperstructure.Figure 5-11. StorageLocations AandBInstall two truss rods (10) to top of carrierframe, one on left side, behind cab, and theremaining one on right side of cab. Installfour pins (12, Figure 5-11 A) in connectingpoints.Figure 5A. Installing theTrussRods5-8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
