TM5-3810-305-10 CAUTION DO NOT use a torque wrench for removal  purposes.  Failure  to follow this procedure could cause damage to equipment. 17. Remove 10 upperstructure mounting cap- screws and 20 washers from inside upper- structure, by using a 36 mm socket, two adapters, torque multiplier, short and long ex- tensions, breaker bar, and extension bar (Figure 5-16). All these tools are found in tool box (refer to Tools for Sectionalization, page  5-45).  Set  mounting  capscrews  and washers aside where they will not be kicked off  deck,  as  they  will  be  reinstalled  shortly. R E A R w F R O N T Location TOOLS  REQUIRED  BY  TOOL  NUMBER Ref (REFER TO PAGE 5-45) 1 6 2 8 4 15 25 5 2 6 2 8 4 15 25 3 6 3 2 8 4 15 25 5 4 6 2 8 4 15 25 5 13 6 3 2 8 4 15 25 5 14 6 3 2 8 4 15 25 5 15 6 4 2 8 15 25 5 16 6 2 8 4 15 25 5 17 6 4 2 8 15 25 5 18 6 3 2 8 4 15 25 5 Figure 5-16. Tools Used for Remo al of Mou v nting   Caps crews 5-12 5