TM5-3810-305-10
f.
g.
h.
Start engine.
Swing boom to 2 o’clock position and
stow mast (3) on upperstructure storage
location D (Figure 5-4) using additional
pin from tool box.
Shut engine off.
3. Account for and clean all tools used in assem-
bly procedures. Put away all tools in tool
box.
Lower the LRT 110 Crane to the Ground
1.
2.
3.
CAUTION
When attaching hook block to
hook block tieback, take up cable
slowly while lowering boom to
prevent damage to windshield.
Start engine. Center boom over cab and raise
boom to a 50-degree angle. Lower hook
block down far enough to hook it into hook
block tieback on front of the LRT 110 Crane.
Lower boom to travel position while taking
up slack in cable.
Raise outriggers, lowering the crane to
ground. Retract outrigger beams up to travel
position. Shut engine off.
Recheck stowage of all items used for assem-
bly of the LRT 110 Crane, The crane is now
ready for normal operation.
Figure 5-4. Storage Location D
5-4
4
