Figure 5-13. Rotary Manifold Hoses

Figure 5-41 Tools Used for Tightening of Capscrews

Removal and Stowage of Remaining Parts Used in Assembly

TM-5-3810-305-10 Crane Wheel Mounted Hydraulic Light 7 1/2 Ton (Rough Terrain Crane) Model LRT 110 Manual
Page Navigation
172

TM5-3810-305-10 3. Connect hoses and wiring harness to rotary c. manifold using the following procedure: a. b. Relieve pressure in extend-retract valve circuit by turning ignition switch ON, holding on anti-two block BY-PASS d. switch and operating boom extend-retract lever in both directions several times until pressure is released. Turn ignition switch OFF. e. Connect extend-retract hoses, hooked under tabs (Figure 5-13), onto rotary manifold. f. Remove plugs from winch hoses and stow in tool box. Connect winch hoses H-10 and H-11 to connectors on rotary mani- fold. Reconnect wiring harness on collector ring. The anti-two block system is now operable. Check to make sure the torque arm stop pin, hoses and wiring harness are all in place and connected to rotary manifold. Turn hydraulic reservoir cap 1/4 turn clockwise to close reservoir. Figure 5-13. Rotary Manifold Hoses 5-4 1

Privacy Statement
Press Release
Contact