TM5-3810-305-10
The LRT 110 Crane must be
level prior to extending boom or
lifting loads. To achieve this
condition, outriggers should be
extended to lift carrier wheels off
the ground. Use bubble level
next to the operator’s seat to
insure that vehicle is level. The
bubble must be centered in circle.
Failure to follow this procedure
could cause DEATH or serious
injury.
Hook latch is intended to retain
loose slings or devices under
slack conditions. It is not in-
tended to be an anti-fouling
device. Caution should be used
to prevent the latch from support-
ing any of the load. Periodic in-
spection of latch must be made to
insure its proper operating
condition. Failure to follow this
procedure could cause DEATH
or serious injury.
An operator must be guided by
the Capacity Chart mounted on
vehicle when considering load
weights. Rated loads must never
be exceeded. Failure to follow
this procedure could cause
DEATH or serious injury.
The intent of the information is
to prevent any possibility of
either reverse winding of the
rope on the winch drum, causing
breakage of winch cable, or the
unseating of cable from winch
drum, resulting in uncontrolled
fall of the hook block and load.
Failure to follow this procedure
could cause DEATH or serious
injury.
Never lift and swing a load
directly over operator’s compart-
ment or over ground personnel in
the work area. Failure to follow
this procedure could cause
DEATH or serious injury.
Using an axe or hatchet to cut
wire rope may be dangerous. If
necessary to use, proceed with
great caution. Failure to follow
this procedure could cause
SERIOUS INJURY. Portable
hydraulic and mechanical rope
cutters are available. In remote
areas, however, it may at times
be necessary to use less desirable
cutting methods.
Incorrect cable type or size will
not function properly and may be
dangerous when used. Failure to
follow this procedure could cause
DEATH or serious injury.
1-30
