TM5-3810-305-10
Visually check the condition of the hydraulic oil.
Periodic testing of oil is the safest, most accurate
Thickening of oil or a change in its appearance,
method of determining the condition of the oil.
such as darkening, may serve as an indicator of
An oil sample may be taken through the fitting
when an oil change is needed.
on inlet end of the reservoir return filter. Obtain
hydraulic oil sample for analysis every 100 hours
Clean radiator exterior. Wash radiator with soap
of service.
and water to remove dirt and foreign material
from fins of radiator.
Operator Troubleshooting
1. Engine Does Not Crank
Problem
a. Ignition switch OFF
b. Transmission shift not in neutral
c. Loose battery cables
d. Low battery voltage
2. Engine Cranks But Does Not Start
Problem
a. Out of fuel
b. STE/ICE fuel switch OFF
c. Temperature below 32 degrees F (O degrees C)
d. No fuel at engine
3. Electrical Circuit Non-Functional
Problem
a. Turn ON
b. Shift into neutral
c. Refer to maintenance
d. Refer to maintenance
a. Check guage and fill tank (refer to page
4-l0)
b. Turn ON
c. Use cold start assist
d. Check fuel solenoid wire connection. If
loose refer to maintenance
Remedy
a. circuit breaker tripped
b. Lights will not come on
c. Low battery voltage (below 22 V)
d. High battery voltage (above 29.5 V)
a. Check and reset
b. Check for blackout mode and correct
c. Increase engine speed and observe
voltmeter. If no response, refer to main-
tenance
d. Refer to maintenance
4-1
5
R e m e d
y
Remed
y