TM 5-3810-305-23
0041
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
NOTE
Cover plate must be installed with air inlet on flywheel end. Air inlet must be directly above
cold start atomizer inlet.
1.
Install new gasket (Figure 2, Item 3) and cover plate (Figure 2, Item 2).
2.
Lubricate eight capscrews (Figure 2, Item 1) with threadlock compound and install on cover
plate (Figure 2, Item 2).
3.
Install high-pressure fuel injection lines (WP 0048).
4.
Torque eight capscrews (Figure 2, Item 1) to 18 ft-lb (24 Nm) after high-pressure fuel injection lines
are installed.
5.
Connect battery cables (WP 0076).
2
1
3
M0053105
Figure 2. Manifold Cover Plate Installation.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00046)