TM 5-3810-305-23
0052
REMOVAL - Continued
8.
Remove cotter pin (Figure 5, Item 5) and pin (Figure 5, Item 4) from end yoke (Figure 5, Item 3) and bell crank
(Figure 5, Item 6). Discard cotter pin.
NOTE
DO NOT remove end yoke from throttle cable unless necessary. If removal is necessary,
mark distance from end of cable prior to removal.
9.
Loosen nut (Figure 5, Item 2), if necessary, to remove end yoke (Figure 5, Item 3).
10.
Loosen nut (Figure 5, Item 22) and disconnect throttle cable (Figure 5, Item 1) from weldment. Pull throttle
cable through opening in cab.
11.
Remove spring (Figure 5, Item 7) from hook (Figure 5, Item 10) and yoke (Figure 5, Item 3).
12.
Remove nut (Figure 5, Item 8), lockwasher (Figure 5, Item 9), and hook (Figure 5, Item 10). Discard lockwasher.
13.
Remove two nuts (Figure 5, Item 13), washers (Figure 5, Item 12), and capscrews (Figure 5, Item 11).
14.
Remove two nuts (Figure 5, Item 20), washers (Figure 5, Item 19), capscrews (Figure 5, Item 16), bell crank
(Figure 5, Item 6), and pedal (Figure 5, Item 21) as an assembly.
15.
Remove bearing unit (Figure 5, Item 14) from pedal (Figure 5, Item 21).
16.
Remove two roll pins (Figure 5, Item 15), pedal (Figure 5, Item 21), bracket (Figure 5, Item 17), and bushing
(Figure 5, Item 16) from bell crank (Figure 5, Item 6). Discard roll pins.
2
3
1
4
22
21
5
6
7
20
19
8
12
14
18
10
15
11
9
17
13
16
M0544105
Figure 5. Throttle Control Removal.
03/15/2011Rel(1.8)root(maintwp)wpno(M00058)