TM 5-3810-305-23
0067
REMOVAL
1.
Remove four bolts (Figure 1, Item 1), washers (Figure 1, Item 2), and tubes (Figure 1, Item 3) from control
panel (Figure 1, Item 13).
2.
Disconnect plug (Figure 1, Item 11) from connector in cab at rear of control panel (Figure 1, Item 13).
3.
Remove control panel (Figure 1, Item 13) from vehicle.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
DISASSEMBLY
1.
Remove two bolts and disconnect two wires from BY-PASS toggle switch (Figure 1, Item 5).
2.
Remove nut, washers, and BY-PASS toggle switch (Figure 1, Item 5) from control panel (Figure 1, Item 13).
3.
Disconnect five wires from relay (Figure 1, Item 6). Remove relay from control panel (Figure 1, Item 13).
4.
Disconnect two wires from HORN (Figure 1, Item 12).
5.
Remove plastic nut and HORN (Figure 1, Item 12) from control panel (Figure 1, Item 13).
6.
Disconnect two wires from TEST switch (Figure 1, Item 10).
7.
Remove nut, washer, and TEST switch (Figure 1, Item 10) from control panel (Figure 1, Item 4).
8.
Disconnect two wires from HORN switch (Figure 1, Item 4).
9.
Remove HORN switch (Figure 1, Item 4) by pressing in on spring clips while pushing HORN switch out.
NOTE
DO NOT unsolder connections unless necessary.
10.
Remove nut, washer, and WARNING light (Figure 1, Item 14) from control panel (Figure 1, Item 13).
0067-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00073)
