TM 5-3810-305-23
0071
REMOVAL
NOTE
Tag and identify wires to aid in installation.
Following steps apply to both left and right hand rear light assemblies.
1.
Disconnect electrical connectors (Figure 1, Item 7).
2.
Remove nut (Figure 1, Item 4), lockwasher (Figure 1, Item 5), ground wire (Figure 1, Item 6), rear turn signal
(Figure 1, Item 2), and washer (Figure 1, Item 3) from mounting bracket (Figure 1, Item 1). Discard lockwasher.
3.
Remove two bolts (Figure 1, Item 8), lockwashers (Figure 1, Item 9), ground wires (Figure 1, Item 10), and
rear taillight (Figure 1, Item 12) from mounting bracket (Figure 1, Item 11). Discard lockwashers.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
NOTE
Install wires as tagged during removal.
1.
Install rear taillight (Figure 1, Item 12), two ground wires (Figure 1, Item 10), new lockwashers
(Figure 1, Item 9), and bolts (Figure 1, Item 8) on mounting bracket (Figure 1, Item 11).
2.
Install washer (Figure 1, Item 3), rear turn signal (Figure 1, Item 2), ground wire (Figure 1, Item 6),
new lockwasher (Figure 1, Item 5), and nut (Figure 1, Item 4) on mounting bracket (Figure 1, Item 1).
3.
Connect electrical connectors (Figure 1, Item 7).
0071-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00077)