TM 5-3810-305-23
0073
WARNING
Wear protective equipment while heating and handling bearing cone. Failure to follow this
warning may cause injury or death to personnel.
REMOVAL
NOTE
The following is a maintenance procedure for one work light. Maintenance procedure
for remaining two work lights is identical.
Tag all wire assemblies before disconnecting to aid in installation. Remove tags
following maintenance.
1.
Disconnect two wires (Figure 1, Item 3) from work light (Figure 1, Item 1).
2.
Remove nut (Figure 1, Item 4), lockwasher (Figure 1, Item 5), and work light (Figure 1, Item 1) from boom
(Figure 1, Item 2). Discard lockwasher.
END OF TASK
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
NOTE
Install wires as tagged during removal.
1.
Install work light (Figure 1, Item 1), new lockwasher (Figure 1, Item 5), and nut (Figure 1, Item 4) to boom
(Figure 1, Item 2).
2.
Connect two wires (Figure 1, Item 3) to work light (Figure 1, Item 1).
0073-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00079)