TM 5-3810-305-23
0081
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
1.
Position main MSD-ICE harness (Figure 2, Item 10) in vehicle.
2.
Connect main MSD-ICE harness (Figure 2, Item 10) resistor module (Figure 2, Item 8), tachometer sender
(Figure 2, Item 12), fuel pressure transducer (Figure 2, Item 2), alternator (Figure 2, Item 3), starter solenoid
(Figure 2, Item 5), fuel pressure differential switch (Figure 2, Item 1), shunt (Figure 2, Item 6), batteries
(Figure 2, Item 7), starting motor (Figure 2, Item 4), and fuel solenoid (Figure 2, Item 11).
3.
Install DCA and resistor module connectors on rear wall of cab.
4.
Install clamps (Figure 2, Item 9) and hardware to secure main MSD-ICE wire harness (Figure 2, Item 10).
2
1
3
4
12
5
6
7
11
10
M0163105
9
8
Figure 2. Main MSD-ICE Harness Installation.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00087)