TM 5-3810-305-23
0094
REMOVAL
WARNING
Never disconnect hydraulic lines or fittings before venting pressure. Turn dipstick cap 1/4 turn
to safety notch to relieve pressure. Failure to follow this warning may cause death or injury
to personnel.
1.
Turn dipstick cap 1/4 turn to safety notch to relieve pressure.
NOTE
Tag all hose and tube assemblies before disconnecting to aid in installation. Cap and plug
all ports. Remove caps, plugs, and tags following maintenance.
2.
Disconnect and cap all hydraulic lines to steering cylinders, brake lines, and breather hose.
WARNING
Weight of axle assembly is approximately 1,323 lb (600 kg). Use adequate lifting equipment
to lift and support axle assembly. DO NOT lift over personnel or let personnel walk underneath
suspended load. Failure to follow this warning may cause injury or death to personnel.
3.
Remove two cotter pins (Figure 1, Item 3), washers (Figure 1, Item 4), pins (Figure 1, Item 2), and parking
brake assembly (Figure 1, Item 10) from front axle (Figure 1, Item 6). Discard two cotter pins.
4.
Let parking brake assembly (Figure 1, Item 10) hang by cable (Figure 1, Item 5).
WARNING
Remove jewelry and disconnect battery negative ground cable before performing
maintenance on this equipment. Failure to follow this warning may result in injury or death
to personnel.
5.
Disconnect battery negative ground cable (WP 0076).
NOTE
Tag all wire assemblies before disconnecting to aid in installation. Remove tags
following maintenance.
6.
Disconnect two wires from speedometer sensor unit.
0094-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00104)