TM 5-3810-305-23
0094
CLEANING
Clean parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
CAUTION
Copper sealing washers are not reusable. If a previously tightened connection containing
copper sealing washer(s) is loosened, the washer(s) must be replaced before retightening.
Failure to follow this caution may result in damage to equipment.
1.
Transfer steering cylinders, brake connections, vent hose adapter, and other attaching components to new
axle before installing on vehicle.
WARNING
Weight of axle assembly is approximately 1,323 lb (600 kg). Use adequate lifting equipment
to lift and support axle assembly. DO NOT lift over personnel or let personnel walk underneath
suspended load. Failure to follow this warning may cause injury or death to personnel.
2.
Raise front axle (Figure 2, Item 6) in position under vehicle.
3.
Install eight capscrews (Figure 2, Item 9), washers (Figure 2, Item 8), and nuts (Figure 2, Item 7). Tighten eight
capscrews to 500 ft-lb (678 Nm).
4.
Install four capscrews (Figure 2, Item 1) to connect front axle (Figure 2, Item 6) to front driveshaft spider bearing
(Figure 2, Item 11). Tighten capscrews to 50 ft-lb (68 Nm).
5.
Position parking brake assembly (Figure 2, Item 10) and cable (Figure 2, Item 5) on front axle
(Figure 2, Item 6) and install two pins (Figure 2, Item 2), washers (Figure 2, Item 4), and new cotter
pins (Figure 2, Item 3).
0094-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00104)