TM 5-3810-305-23
0101
CLEANING
1.
Clean parts IAW General Maintenance Instructions (WP 0162).
2.
Remove sealant IAW General Maintenance Instructions (WP 0162).
3.
Clean all parts and surfaces with solvent cleaning compound IAW General Maintenance Instructions
4.
Dry parts with compressed air.
END OF TASK
INSPECTION
Inspect parts IAW General Maintenance Instructions (WP 0162).
END OF TASK
INSTALLATION
WARNING
Wear protective equipment while heating and handling spacer. Failure to follow this warning
may result in serious injury to personnel.
1.
Lubricate and install new input yoke seal (Figure 2, Item 5) flush.
2.
Heat spacer (Figure 2, Item 3) to approximately 350F (176C). Install spacer and
trunnion (Figure 2, Item 4).
0101-4
03/15/2011Rel(1.8)root(maintwp)wpno(M00111)